Luz de alarma LED universal para exteriores, 12 V/24 V, luz estroboscópica intermitente, lámpara de advertencia de emergencia para montaje en pared, para abridor de portones.
Luz de alarma LED universal para exteriores, 12 V/24 V, luz estroboscópica intermitente, lámpara de advertencia de emergencia para montaje en pared, para abridor de portones.
Couldn't load pickup availability
Instrucciones de seguridad:
1. Por seguridad, lea atentamente el manual del usuario antes de la primera operación. 2. Asegúrese de que el suministro eléctrico esté apagado antes de conectarlo. El producto se fabrica sin fusible. 3. Este sistema no debe poner en peligro la vida ni la propiedad durante un fallo de funcionamiento, ya que se han eliminado los riesgos de seguridad.
Especificaciones Voltaje de funcionamiento: 12-265 V CA/CC Capacidad de carga: 1,5 W Peso: 156 g Frecuencia de parpadeo: 1 Hz Método de instalación: Vertical/horizontal Temperatura de funcionamiento: -20 °C a +60 °C N
Mutiple Voltage Flash Lamp
Antenna This is used to extend the effective distance of controller Waterproof and dustproof It is made of plastic material IP 54 .
Notice：
1,Terminal 1 is for connectino thepower input; working voltage is 12-265VAC/DC.
2,Terminal 2 is for connecting the antenna of RF controller to extend the effective working distance
Instruction:
After power the lamp on, LED will start fashing in 1HZ(default setting).
sW1 is the switch for selecting flashing or on mode of the lamp.CAP short connectsthe 2 pins; the lamp is in flashing mode. Remove the CAP from 2 pins, the lamp is inon mode.
Be Careful, the whole board includes the components are with high voltage. Alwaysmake sure power is off before you open the cover
Installation：
Open the package; take out the products and all the accessories. Removing the antenna by rotatinganticlockwise.
Mark 2 holes on the wall by using the fixing hole of bracket.
Drilling two 6mm diameter holes and one 10mm diameter hole. Then put the expansion plug intothe 6mm diameter holes. Put the wires through 10mm diameter hole.
Put the power wire and antenna through the cable holes in the holder. And fix the holder to thewall by provided 4mm*30mm self-taping screws.
Connect the wire and antenna to the correct terminals.
Put the cover back and make sure the cover is fastened with the bottom base without any gap.Then screw the antenna up and turn clockwise to make it tight.
Always install the holder and lamp upright to the ground. Horizontally installation may cause therain go inside the lam and damage the board.
wide range of uses:
Garage doors, Electronic gates, Barrier gates, sliding doors, automatic doors, rolling doors, shutters
Electrical appliances/Home automation i.e. lights, Alarm system, access control system
The package contains:
1X flash lamp
1X antenna
2X Screws
1 X English User Manual
